![]() If Modscan 32 is communicating with the PFC:ġ: *** Device Not connected *** in the editor window will not be displayed.Ģ: Number of polls and Valid Slave response counters will be counting up Set up the communication parameters and then click OK. ![]() MODSCAN32 SOFTWARE MANUAL SERIAL(This Document was written using Modscan32 by Wintech )Ĭlick on Connection to open up the communication parameter windowįigure 2: Serial Setup Window Set Comm Parametersįigure 3:Ethernet Setup Window IP Address ![]() The Modbus Serial PFC default communications are set to: Contact Wintech to get a licensed copy of the software to be able to run the software. The unlicensed version will run for 3 min. This software can be downloaded from the internet at. The software used in the example to pass data is MODSCAN32 by Data is placed into registers and then sent or read to the Modbus is an address type of protocol that communicates through the serial port of a PC/PLC. The modules are placed in the node as follows: Taking the example node from the Get Started Quick, the configuration is described as follows. MODSCAN32 SOFTWARE MANUAL MANUALThe Modbus Users Manual can be downloaded from the web site Application note The following equipment and software were used to Configuring and Network the Modbus network.ĭownload from Serial Com port for RS-232 or RS-485 Cardįor other details about WAGO Modbus & 750-8xx please refer to the WAGO This document is to be used with the example node from the document Get Started Quick. The purpose of this document is to provide a step-by-step procedure for Configuring & Networking the WAGO 750-812, -814, -815, -816 & -842 Modbus Please note the detailed description in the specific manuals. New hardware and software versions may need to be handled differently. This application note is therefore only valid for the described installation. This application note is based on the stated hardware and software of the specific manufacturer as well as the correspondent documentation. Please direct any requirements pertaining to a modified and/or new hardware or software configuration directly to WAGO Kontakttechnik GmbH. All other changes to the hardware and/or software and the non-conforming use of the components entail the exclusion of liability on part of WAGO Kontakttechnik GmbH. Modifications are only admitted within the framework of the possibilities documented in the manuals. WAGO Kontakttechnik GmbH declines all liability resulting from improper action and damage to WAGO products and third party products due to non-observance of the information contained in this manual.įor each individual application, the components supplied are to work with a dedicated hardware and software configuration. The use of the product detailed in this manual is exclusively geared to specialists having qualifications in PLC programming, electrical specialists or persons instructed by electrical specialists who are also familiar with the valid standards. Non-observance will entail the right of claims for damages. Reproduction, translation and electronic and photo-technical archiving and amendments require the written consent of ![]() Any use of this manual which infringes the copyright provisions stipulated herein, is not permitted. This manual is copyrighted, together with all figures and illustrations contained therein. To ensure fast installation and start-up of the units described in this manual, we strongly recommend that the following information and explanation is carefully read and adhered to. We wish to point out that the software and hardware terms as well as the trademarks of companies used and/or mentioned in the present manual are generally trademark or patent protected.ġ Important comments. However, as errors can never be fully excluded we would appreciate any information or ideas at any time. 750-8xx Modbus PFC Configuring & Networking The 750-812, -814, -815, -816 & -842 Modbus TCP Application note A2021_01Įvery conceivable measure has been taken to ensure the correctness and completeness of this documentation. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |